Choose the size closest to your waist measurement. Because every belt is made to order, we're happy to make any size not listed in our guide at no additional cost. Just get in touch at info@bajaff.com.

Option 1 (recommended): Use Your Waist Measurement

1. Wrap a measuring tape around your waist where you normally wear your belt, over your trousers or jeans.
2. Pull the tape snug, but not tight, then round up to the nearest centimeter or half inch.

Option 2: Measure a Belt You Own

You can also use a belt that already fits you well.

1. Measure from the fold where the buckle is attached to the hole you use most often.
2. Round up to the nearest centimeter or half inch.

Additional Sizing Notes:

• If your measurement falls between sizes, choose the next size up.
• If measuring directly on your body rather than over clothing, add approximately 3 cm (1 in).
  
• For a longer draped tail, size up by two to three sizes.
  

Standard Width Belts | 40 mm (1.6 in)

Slim Width Belts | 20 mm (0.8 in)

*Standard Width belts have five adjustment holes, while Slim Width belts have four. Belt sizes are measured to the centre hole (third hole on Standard Width belts and second hole on Slim Width belts). All measurements are taken excluding the buckle.